No chemicals
It completely eliminates anti-limescale and anti-corrosion additives, with the savings and environmental benefit that entails.
A patented physical treatment, with no chemicals. In a sanitary water circuit it puts an end to scaling and corrosion; in a cooling tower it also saves water, chemicals and biocide.
Request your assessment
Calcat Treatment® acts physically on the water to stop calcium and magnesium salts precipitating inside the pipework. In sanitary water circuits that means the end of scaling and corrosion in pipes, boilers, heat exchangers and equipment. In cooling towers and evaporative condensers it also means being able to run at higher concentrations, with far less blowdown and no antiscalants.
Benefits
It completely eliminates anti-limescale and anti-corrosion additives, with the savings and environmental benefit that entails.
Prevents the breakdowns, downtime and replacements caused by limescale and corrosion in pipes and equipment.
In cooling towers and evaporative condensers the circuit runs at higher concentrations, which sharply reduces blowdown discharge and biocide spend.
Reduces chemical discharges and the environmental impact of treating your facility's water.
It adapts to your existing water network, with no complex works or major service interruptions.
We monitor the condition of the water and equipment so you can see the treatment's real impact.
How we work
We analyse your water network, its hardness and the critical points where limescale and corrosion cause the most damage.
We design the right Calcat solution for your case, sized for your consumption and equipment.
We deploy the system with the least possible service interruption and no complex works.
We verify the results and support you over time to guarantee maximum performance.
60–70%
Water saved in cooling towers (real case)
0
Antiscalant products
<0.10 mg/l
Iron in the treated circuit
We study your case with no obligation and tell you how much you can save with Calcat Treatment®.
